You are reading a single comment by @Sam_w and its replies.
Click here to read the full conversation.
-
Ah that’s not so bad, apart from the fact I don’t use Kraftform just their normal ones, so would need to switch over.
Have you seen powertoolmate.co.uk they often do decent bundle deals on Wera stuff
Sam_w-
I tend to use a hex holder for 2/3/4mm drill bits for guide holes,
then suitable Torx screws in the Wera magholder,
so,
I'm tempted by the Turbo Kraftform for precision/on view work.
I tend to buy from D&M Tools, Twickenham,
or,
even Toolstation who used to stock a wider range of Wera stuff.
I'll check out powertoolmate.
Thanks.
mespilus
Just under £60.
Should they be run this year,
I can probably wait until the Autumn trade shows for a 10% discount at the show.