3D Printing

You are reading a single comment by @Rik_Van_Looy and its replies. Click here to read the full conversation.

•

Engineering101 in reply to @Rik_Van_Looy

Sadly they wanted c.£100 for my drip tray replacement (see upthread)... Probably a little over the top!

•

Rik_Van_Looy in reply to @Engineering101

Indeed - the cost is in mass of material and space it takes up in the powder chamber. Geometric complexity is free but MJF powder is quite expensive. FDM is definitely the answer for printing bricks!

•

Engineering101 in reply to @Rik_Van_Looy

3D printing is a whole new world to me... Lots to learn! Thanks for the tip.

About

Avatar for Rik_Van_Looy @Rik_Van_Looy started