Home DIY

You are reading a single comment by @dbr and its replies. Click here to read the full conversation.

•

Hovis in reply to @dbr

Hmm, I just replaced it with same spec as the original Makita blade it came with. I notice your kerf is 2.15mm vs my 3mm, any issues with deflection?

I mean, if this is in the week when it went blunt, we may have our answer. That being said, ally won't kill a blade completely, a single small cut on ally shouldn't make a drastic difference.

@nefarious Hard to say, I feel like it was going dull before I did that cut, but it was only the one and not a big cut by any means so I'd have thought it shouldn't have hurt it.

•

dbr in reply to @Hovis

I’d be very surprised if you could get a chop saw blade to deflect without some super sketchy dangerous setup.

•

Hovis in reply to @dbr

Probably not for 90deg cuts but possibly for bevel cuts? Anyway think I'm sold on fewer teeth and thin kerf for the win.

About

Avatar for dbr @dbr started