Hmm, I made a 90 degree angle and it takes up a bit too much room. Stick with the more acute version.
To get it to fold properly you need a bit of spare room at the axle. If you make it more square than I did or just keep an eye out for tolerances you'll be fine.
Recessing the holes for the dowel ends with a forstner was time consuming, the hole is deeper than the forstner so you just have to guess when you're deep enough, and not going to go through the other side.
Hmm, I made a 90 degree angle and it takes up a bit too much room. Stick with the more acute version.
To get it to fold properly you need a bit of spare room at the axle. If you make it more square than I did or just keep an eye out for tolerances you'll be fine.
Recessing the holes for the dowel ends with a forstner was time consuming, the hole is deeper than the forstner so you just have to guess when you're deep enough, and not going to go through the other side.