You are reading a single comment by @atk and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@atk
Another question on this room Need to replace a couple of split boards out of shot. You just about can see in photo some of the gaps between boards are quite large (10-12mm), both along the length and at the joins.
To fix this, can I "just" lift all boards and relay them closer together (starting on opposite wall pictured, numbering, watching out for wires/pipes etc.) fitting new boards where needed? Or is there something I'm missing?
Will most likely need to fill smaller gaps with slivers, then sand and stain the whole thing...