You are reading a single comment by @Nef and its replies. Click here to read the full conversation.
  • making this, to go on the wall, for storage jars.

    1 - it would be madness to try to cut the vertical supports so precicely - just make them all 202 and the screws/glue will pull them all together?

    2 - it will attach to a wall on the LHS, so, three screws in there. What about at the back? A 20mm square baton screwed into the wall then hang the shelving off of that. One baton, or one baton per shelf?

  • would be madness to try to cut the vertical supports so precisely

    Not at all. 6mm is a huge difference, especially for a cabinet. How are you cutting them? What's the reason for the difference?
    If you can make it so all the uprights are the same I'd do that,

About

Avatar for Nef @Nef started