You are reading a single comment by @Emyr and its replies.
Click here to read the full conversation.
-
a rather large trailer
Is there a build thread for this?
Not yet, but there will be once I've finished it, with a cost breakdown. Should end up about 2/3rd the cost of a comparable trailer imported from the EU, not accounting for my time. (Especially since if I was paying for my time, it would have been cheaper for me to buy a desktop mill rather than faffing around with sawing, filing and dremeling the axle mounts).
Emyr
hugo7
Is there a build thread for this?
Cheers.