You are reading a single comment by @PhilDAS and its replies.
Click here to read the full conversation.
-
My first idea was to just push my hand drill sideways in the slot. But i guess I could drill it out too.
Sorry to be the one always replying :)
Drill bits only have cutting faces on the end for drilling downwards. You'd need an end mill bit for cutting along like that. I'd suggest a dremel type rotary tool if you have one or a small file
PhilDAS-
Or even hack saw the slot all the way out — I can't see that compromising whats asked of the strength, not to mention it's quite common on front rack fixtures.
-
I don't mind. I'm happy someone is :•)
I know about drill bits but it works if you move the drill up and down. At least on wood. Don't have a Dremel or file that small unfortunately.
🅑🅐🅣🅣
nogk
I got this adapter to make the Supernova front light sit under the fork crown, because thets where the fork is drilled. Turns out its slot is about 1-2 mm too short.
I’m guessing it wouldn’t effect it noticably to remove that little material. But what method would you suggest?
I have a pillar drill and a hand drill. My first idea was to just push my hand drill sideways in the slot. But i guess I could drill it out too.