Tester's T3

You are reading a single comment by @gbj_tester and its replies. Click here to read the full conversation.

•

mustard in reply to @gbj_tester

Do you think these could be converted to 12mm TA? I'm mulling over putting my ENVE tubs on to disc hubs but 20h 12mm hubs are proving a challenge to find. I should probably just sell them but i feel they are worth more to me than I'd get.

I also found these on eBay, I might just take a punt for £20

•

gbj_tester in reply to @mustard

found these on eBay, I might just take a punt

I'm sure the "12mm axle" refers to 12mm ID bearings. You'd need to take them out and fit a precision loose spacer tube to keep axle clamping loads from preloading the bearings. That sounds like an even worse idea than hacking the Wheelsmith one

•

mustard in reply to @gbj_tester

Thanks, you are probably saving me from myself at this point. I should really just admit it's a bad idea, sell the ENVE wheels and use the money for some Light Bicycle rims.

About

Avatar for gbj_tester @gbj_tester started