Crown race setting tool and bearing press SE5

You are reading a single comment by @Colm89 and its replies. Click here to read the full conversation.

•

Colm89

I ended up just slowly tapping the crown race on with a hammer and piece of timber. I got it down as far as i could (looked fully seated to the eye) and the first bump on my first ride gave it the last little push it needed.

•

spaniel in reply to @Colm89

Thanks. Did you core out the piece of timber or just use it a drift?

I'm tempted to go to and get a bit of PVC pipe. Just worried because I need to bash on a hope reducer crown race (not split) and the accounts I have seen suggests it requires a fair walloping.

About

Avatar for Colm89 @Colm89 started