Yes, the test is fairly straightforward. The real skill with asbestos testing is removing a sample(s) in such a way that minimises the risk of producing airborne particles.
The asbestos specialists that I used to work with when I did commercial renovations used chisels that were sharp enough to make most chippies jealous. They would place the chisel on the piece of material to be sampled then place the sample bag over it forming the tightest possible seal and shave off a tiny sliver. Once this was done they would "pinch" the top of the bag together without removing it from the surface to try and trap as much contaminated air as possible.
If you are concerned you can get asbestos specialists to carry out a survey for you don't know how much it would cost though.
Well, a chunk of the coating actually came off when I tried to glue a fire alarm bracket after failing to locate a joist, so I could use that I guess. There are a couple of different surfaces that have potential for asbestos so I should probably just see how much a small survey is.
Yes, the test is fairly straightforward. The real skill with asbestos testing is removing a sample(s) in such a way that minimises the risk of producing airborne particles.
The asbestos specialists that I used to work with when I did commercial renovations used chisels that were sharp enough to make most chippies jealous. They would place the chisel on the piece of material to be sampled then place the sample bag over it forming the tightest possible seal and shave off a tiny sliver. Once this was done they would "pinch" the top of the bag together without removing it from the surface to try and trap as much contaminated air as possible.
If you are concerned you can get asbestos specialists to carry out a survey for you don't know how much it would cost though.