You are reading a single comment by @Howard and its replies.
Click here to read the full conversation.
-
I've used one to drill through floor joists.
Slow and steady worked ok.
Turn off the hammer action.
-
May sound obvious, but don't get a shit one.
Probably also best to go slow and steady as TW said.
The internals exploded on the one I used with my dad when I was younger. So maybe also have a look at torque recommendations.
-
They’re a pain to use, but you have little choice. The cheap ones are awful.
NotThamesWater
hugo7
Sharkstar
jsabine
@Howard
I'd like to make some holes in the internal edges of a window recess - but drill clearance is an issue. Possibly a dumb question, but what are my options, other than put the holes in at an angle?
I see you can get right angle drill adapters, things like this - are they any good?