Home DIY

You are reading a single comment by @bright and its replies. Click here to read the full conversation.

•

Soul

I’ve got an electric planer and a random orbital.

What’s going to be better to get this flat with? There are 0.5-1mm differences all over the thing.

•

bright in reply to @Soul
might be able to get it milled professionally...

hard (not impossible) to do by hand.

I personally used a straight edge to fight high spots and a belt sander. took a few evenings. here it is before oil. its 8 feet long. down t0 500 grit

1 Attachment

•

lynx in reply to @bright

Would it have been easier/simpler to put though a thickneser before assembly?

Having lifted scratched wood flooring, taken 1mm off to remove the marks then reinstalled then re varnished when installed properly. It was to make a point that the floor was poor and the instal was worse.

About

Avatar for bright @bright started