I gound a thick washer that must've been between the bolt and extraction cap. I'm not sure if it was originally flat, but it's concave now. The one in the top picture seems flat, which leads me to believe I've messed up somewhere.
That's reassuring to know that I can unscrew the bolt and replace it when the new one comes. Thank you!
I'm not sure if it was originally flat, but it's concave now
Oops. You were going some to squash that while threading in the extractor ring, which requires a tightening torque of 12Nm and should spin in by hand until it abuts the bottom of the counterbore.
I gound a thick washer that must've been between the bolt and extraction cap. I'm not sure if it was originally flat, but it's concave now. The one in the top picture seems flat, which leads me to believe I've messed up somewhere.
That's reassuring to know that I can unscrew the bolt and replace it when the new one comes. Thank you!