On One Pompino owners...

You are reading a single comment by @rhb and its replies. Click here to read the full conversation.

•

pakchoi

I’ve got a Baby blue Pomp, think it’s a V1, with 135mm rear hub spacing. (Frame and most other bits bought from a selection of very nice people on this forum. ). I’m trying to run it as a SSCX over the summer, but am struggling with punctures and track wheels that are not really up to the job. Ideally I want some off the shelf tubeless ready clincher wheels with 135 OLD. However that would appear to be impossible unless I go custom, which would basically quadruple the cost of the entire build. Any idea folks?

•

rhb in reply to @pakchoi

Doesn't fully answer your question, but you could consider using some genetic (or similar) chain tugs inside the dropouts as spacers, meaning less reliance on 135mm hub options so you might then find an otp wheel that meets your needs.

•

pakchoi in reply to @rhb

@rhb, yes, that is a very good idea - thank you! Any reason for the genetic recommendation or would any do. I’ve already got a pair of very similar On One chain tugs you see...