-
tl'dr.
800 shitting decking screws, or do I just hammer it to death and throw it in the "general rubbish" section of the tip.
Greenbank-
Do the screws still being in the wood matter? I’ve never bothered getting 100% out - it’s not always possible anyway.
I also reckon you’re being very optimistic with 5s/screw if they’ve been there a while. -
hammer it to death and throw it in the "general rubbish" section of the tip.
Cut it up with one of these
Then throw it in the general rubbish.
-
If it’s been there any amount of time then I reckon you will get 25% of them out, impact driver would be my tool of choice to try. If not just get destructive, if the screws are in a straight line run a circular saw either side of the screw line, means you have consistent lengths and still no screws but takes no time to do.
Dramatic_Hammer
Bobbo
Sam_w
TL'DR.