You are reading a single comment by @Airhead and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Airhead
Trying to drill a few holes in some hardened (?) steel plate but having some trouble. First hole went fine, punched it, pilot hole then stepped up to final size. For the second one for some reason the bit just won't remove any material. Got a dimple, but the bit just spins, spins and spins. Snapped a few bits, bought a fancy cobalt bit set, still can't get through it.
Can anyone offer some wisdom as to what I'm doing wrong? For reference, its a 3 mm plate, the foot pedal on a workbench castor. Combi drill on low speed.