You are reading a single comment by @Brommers and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Brommers
So the saga of trying to set my tyres up tubeless continues. The front one held air all night and is fine but the rear one just continues to leak air from the bead of the tyres. It is seated on the bead and will hold air but its not sealed.
I already put the sealant in assuming it was seated as it was on the bead. I just let all the air out, went round with some warm soapy water and pumped it up again to around 60 PSI to try and seat it properly but it is still leaking air from the bead, I can see it clearly now it has soapy water on.
Any suggestions?