-
• #8027
Really fucking nice. Took you long enough!
-
• #8028
lol got distracted with other projects
The ongoing N+1 😂 -
• #8029
Finished the pomp
ID on stem?
-
• #8030
The one and only gas pipe
-
• #8031
Here’s my pomp.
EDIT: NDS fail, what was I thinking
1 Attachment
-
• #8032
Stra bella la forca è la tsunami di aliexpress?
-
• #8033
si è proprio quella peccato che non sono neanche riuscito a provarla :(
-
• #8034
Davvero top, che copertoni fitta?
-
• #8035
Ah ma la tua è perno passante?
-
• #8036
credo dei 40mm per ora ci sono dei 25 ma ci passa una mano intorno. mi sa che in acciaio non la fanno perno passante.
-
• #8037
Que?
-
• #8038
anyone know of a smallish one up for sale anywhere?
-
• #8039
Pomp now in full time dadbike mode... actually very fun doing SS, with a tiny gear and wide bars to get up hills.
Have been bimbling around offroad at a very slow pace, such a good way to spend an hour or so (longer when lockdown is over).
(Front brake cable isn't as strained as the picture looks)
1 Attachment
-
• #8040
.
2 Attachments
-
• #8041
SUMMER MODE
After around 3000km. this past Winter with pretty much no Service at all, I've treated mine with some new bits and cleaned it properly...
1 Attachment
-
• #8042
Don’t think your pictures are working?
-
• #8043
Crappy pic, put cx comp and the Crosslight fork back onto my Pomp. V.tired chain replaced after ride, chainring cleaned too. Still not sure about the stem/bar combo. Might switch the canti brakes over from my Kaffenback too. I need a little thumb bell to go by my grip as previous bell was in the huge spacer stack but no room for that now. This will be my allotment lockdown to & fro ride. /csb
1 Attachment
-
• #8044
perhaps not that helpful, but i've found 3 small bells in the garage recently if you want any? the cheap type that come with OTP bikes
-
• #8045
Very kind thanks. I reckon there's some similar knocking about my bike room, i'll shout if not though.
-
• #8046
@14nng on Instagram
1 Attachment
-
• #8047
Still anti, the cx fork steered is too short for my canti-hanger spacer doofer so my mis matching fork is back on to allow the switch from mini v.
Lower rise stem plus levelled the bars and saddle a bit too.
Fun to ride on a short blast around the local woods again.
Edit: chain looks a bit tight in the pic, it doesn't feel it now, unless there's a tight spot I've missed.
Edit 2: longer steered means bell is back on the spacer stack
1 Attachment
-
• #8048
Here’s mine.
Got the stays crimped to fit DA cranks. Weighs a fucking metric ton but it’s my all time favourite commuter. Will probably get it resprayed some point. Rack lyfe is pretty sweet, burger bell: DING DING!
-
• #8049
Photo 1
1 Attachment
-
• #8050
Photo 2
1 Attachment
Looks fantastic