You are reading a single comment by @bens0n and its replies.
Click here to read the full conversation.
-
How strong does it need to be? It looks like it's going to have a rod screwed into the middle.
-
Depends on what it is going to be used for. If it is to go onthe underside of a table/desk top for legs to screw into, then you could use something like a truss head screw with a wide enough head (>12mm) over even washers to make the head area wide enough.
-
Mounting a hangboard onto a pull-up bar? ;)
fizzy.bleach
stevo_com
Drakien
@bens0n
hi everyone, hope this is an okay place to ask but let me know if not and I can delete!
Basically, I need to attach one of these:
to a piece of plyboard that's 25mm thick. The holes in the flange are 12mm diameter, and the flange is 14mm deep. What's my best option? Should I be looking for wood screws that are 12mm in diameter and about 30mm long? Do these even exist?
Thanks and apologies again if this is in the wrong place!