I just used this method for a rounded off Allen bolt. Worked a treat, but had to hammer for a good 10min to get it in properly.
The annoying thing is when you hammer it in good and tight, go to put the handle on only for it to fall out.
Had good results holding the bit with a vice grip (which acts as a useful handle).
I used a hex key and held it on the long end, hammered on the bend. Will fuck up my key in the end of course. Not smart..
@|³|MA3K started
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
I just used this method for a rounded off Allen bolt. Worked a treat, but had to hammer for a good 10min to get it in properly.