Home DIY

You are reading a single comment by @tbc and its replies. Click here to read the full conversation.

•

Airhead in reply to @tbc

To be successful with the kerf cuts you should have tried taking material out of the face of the skirting in this case. Cuts on the back if you had wanted to bend it around the external radius of a corner. Even writing it seems wrong but I had to do it with some 9mm Mdf under a sink recently.

•

tbc in reply to @Airhead

That does make sense. So the gaps you make by cutting squish together.

Anyway - this seems to have worked, albeit inefficiently.

I used a flat surface (spirit level) to line them up, then duct tape to keep them together but flexible, and then Gripfill/panel pins to attach them.

•

Airhead in reply to @tbc

If you had done it the other way you would only have saved lining them up and taping. If you've not skimmed them already you could make a template that matches the skirting profile and run it over your slices.

About

Avatar for tbc @tbc started