You are reading a single comment by @gbj_tester and its replies.
Click here to read the full conversation.
-
Your cable clamp washer should align with the shoulder on the body. I don't think that's the problem, but looking at it is hurting me too much to consider the real issue 😥
Have you checked that the low limit screw is backed out far enough?
1 Attachment
-
gbj_tester
-
Realized that myself, just quickly fixed the cable to take the picture, sorry for your eyes.
Limit screws are of course adjusted properly - thought this was the case at first as well, but the derailleur isn't even touching the limit screw when it seems like I'm almost breaking the shifter. Derailleur also isn't hitting the cassette or spokes or anything either.
slothy
Rear derailleur problems: Trying to set up an XT M-8000 system, can only shift to the second lowest gear (picture attached below is in second lowest); after that, I have to push really hard to shift down further and the derailleur only moves ~half of what it should. Looking at it, seems that the cable is at an odd angle and can't really be pulled more towards the cable stop. Derailleur is mounted correctly, hanger is new.
Probably a fairly obvious solution to it, but I don't see it. Any ideas?