On One Pompino owners...

That is great, good work.

@bankiren's bike (actually a Kaffenback)

Another carbon fork:

-> https://www.lfgss.com/comments/13125263/

Spending on my Pomp is going on hold for a while anyway, I just looked at what was on my credit card and also ordered a load more tubes from Ceeway.

The tubes might build into something that will make my Pomp somewhat obsolete anyway...

https://flic.kr/p/22uz2fV Old pic of mine with an Easton cx carbon fork

Have you got a photo with 650b setup on Pomp? Thinking of doing it with a surly lht disc fork..

Here's mine with 650B tires.

Is that a 650b pomp? Looks good!

Are there any track cranks that people have found will clear the chainstays on a pompetamine?

Sweet! Would the rear fit 43mm gravelking sk with a fender?

Are the chainstays on a pompino and pompetamine the same? I have a pompino and I have omniums on mine, bit tight but they work

I don't think so: 120mm rear vs 135mm

Quick measuring: Pompetamine Chainstays are ~110mm wide at 185mm from bb

sram omnium is 110mm between crankarms (page 23 in attached pdf)

so no... (or very close)

Edit: but then it seems to work here (with 170mm cranks): https://www.pedalroom.com/bike/on-one-pompetamine-35130

1 Attachment

• road_cranksets_fram_fit_specs_gen_0000000004165_rev_b.pdf

Forgot about that, sorry, brain fart

I had to make the slightest of bevels (less than 1 mm) on my 165 mm Omniums to fit them on my Pompetamine, but no issues after that.

Don´t you have problems with the cranks hitting the stays under flex?

Not track cranks, but in a v1 pomp the middle ring of a 4700 tiagra triple chainset is absolutely bang on for spacing.

Thanks all.

I have a pompino V3 also, and had to have the chainstay dimpled to fit omniums in the past (I've since sold these).

I currently have sram road cranks on both my pomps. They're great except being 110 bcd, so I'm wondering about getting a whole new crankset instead of searching high and low for a 110 bcd 46 or 48t chainring (I know that J&L ones are available on eBay).

I have a v3 size small and omnium fitted fine, i need a spacer to fit an on-one track crank.

Stronglight? Or Surly stainless. And check Spa Cycles and SJS, I'm sure I got a 46t somewhere a while ago

Nope. Nothing flexes enough for that to happen.

Not sure. I barely fitted 48mm slick tires. I guess you'd need at least 50 or 52mm fenders to get over the 43mm tires...

New cheapo 47b tyres from Planet X.
So damn comfy.

1 Attachment

nice, which ones are they?

Do you think the rear would fit with a full mudguard?