You are reading a single comment by @jahknob and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Howard
@jahknob
Hope I haven't completely missed a thread that would answer this question, but does anyone happen to know of an engineer with a workshop with mills/lathes/cutting tools within the M25 who could take on small, simple bicycle-related one-off projects without charging silly money?
It's a bit of a long shot, but I'd rather get it done right and pay for it than attempt it myself and make a mess of it. The type of job might vary a bit, but usually similar to this one..
I need to get a (steel) rear wheel axle machined to make the flats a bit longer, which will alter the spacing, so the wheel will fit correctly without having to attempt to spread the dropouts.
Any tips or suggestions gratefully accepted.