You are reading a single comment by @drøn and its replies.
Click here to read the full conversation.
-
I'm in the same boat.
I just bought a near new set of hagons in the stock 310 mm, but now there's a set of koni sp3 330 mm laughing at me. I'm sorely tempted, but not made of money either.
Also while the change won't be too bad for steering, my bike has a drive shaft joint that apparently don't like to be too much out.
drøn
pdlouche
What a pain, nearly found a pair of Hagon’s cheap but measuring they’ll be too long. GN125 has 310mm on, but I want to raise the rear. Hagon’s I found were 360, which would be too much of a change.
Was hoping to find 320 or 330, at a push 340 could get away with? Bike is incapable of speeds over 70mph anyway, and isn’t a knee-down racer, but I don’t want too radical a change in geometry.
Getting rearsets put on at some point soon, so I really wanted a little bit more height.