You are reading a single comment by @hugo7 and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
gbj_tester
@hugo7
I have a stepped(?) hole where the M6 threaded section is threaded.
The non-threaded shoulder(?)/widest part of the hole is 6.7mm.
Is that enough meat to rethread to M7, or should I drill out to M8?
Cheers.
(The step was obviously part of a manufacturering process, but now I can't see any reason not to thread the whole section and if anything it would make it stronger)
1 Attachment