You are reading a single comment by @chez_jay and its replies.
Click here to read the full conversation.
-
https://www.youtube.com/watch?v=tE3h4nmDdOo
Have you tried this? Did the trick for me, no faffing with tape. -
Which doesn't seem significant
It might not seem significant, but it is. The Mavic UST spec calls for a bead seat diameter tolerance of ±0.35mm
Tijmen
gbj_tester
@chez_jay
As a complete neophyte I have a question about this point in the first post:
I assumed this is because it increases the effective diameter of the rim bed, therefore closing the gap for air to escape. Now I have a roll of tape to potentially beef up my pre-taped rims, I realise 1 layer is only going to increase the diameter by under 0.3 mm. Which doesn't seem significant.
Or does 'put an extra layer of tape on' mean 5 layers?
(I'm at the point where I've successfully mounted one tyre fine with a CO2 inflator, track pump having failed, but the other - same tyre and same rim - seems nowhere near mounting)