You are reading a single comment by @Bobbo and its replies.
Click here to read the full conversation.
-
If it's a question of updating the existing kitchen (assuming the kitchen units are not shot) you could try just replacing the doors. Take them off, along with any trim pieces (plinths, pilasters, infil panels and show end panels) and measure them accurately. You can then go to a cutting service like cutwrights who can provide you with cut and edgebanded boards made from a variety of different materials all of a very high standard. They can even make shaker style doors. You can also get matching shelving units made up with the materials they supply.
Bobbo
Sounds good, and to be honest we were thinking of keeping the existing worktops as they're not too bad. It was more just a case of updating the units and doors below the worktop.
We were going to replace the high level units with open shelves.