VMB Vintage Modern Bicycles, Postmodern (classic style) and Custom parts (drillium, WW, replica...)

You are reading a single comment by @PhilDAS and its replies. Click here to read the full conversation.

•

Carabo in reply to @Gaston

Epoxy won't add a lot in the way of structural rigidity 8)

Not a set up I'd personally run... too scared stress will cause sheering on the threaded area.

I'd rather cut the threaded section off and put a steerer extender in (BBB BHP-20)

•

PhilDAS in reply to @Carabo

I'd rather cut the threaded section off and put a steerer extender in

Presumably only if the bottom of the threaded section was above the top bearing

•

Carabo in reply to @PhilDAS

Not only if that. I've used this particular BBB extender to extend ahead Forks even.
•

mattyc in reply to @PhilDAS

You’re a budding frame builder aren’t you? Fancy doing a steerer swap for me? And low rider rack mounts? 😬🙌

About

Avatar for PhilDAS @PhilDAS started