You are reading a single comment by @grams and its replies.
Click here to read the full conversation.
-
That whole rear cable routing/lengths is ghastly! Also:
- Dynamo cable from headlight to rear light isn’t meant to go through the front hinge frame loop. Also the routing past the fork looks questionable.
- Shouldn’t a new bike have curved brake pads?
I don’t know if it’s “wrong”, but the exposed red wire going to the rear light looks super shonky.
- Dynamo cable from headlight to rear light isn’t meant to go through the front hinge frame loop. Also the routing past the fork looks questionable.
grams-
@lynx too
aye.cabling needs a tidy and tying together
brake pads are not set right and wont be tight
Front wheel "axle protector" aka packaging left on
rear brake inner cable too long by my standards - hence why its bent over.
front dynamo routing through frame loop is incorrect
yes - rear light red wire doesnt look quite right.good eyes!
I expect this from Evans...
sbbohr
Ok i'll bite:
Photo one - Badly aligned brake pads to rim, signs that the mudguard flap poorly fitted.
Photo two - Brake pads again.
Photo three -Cables look far too tight.
Finally why not use black wheels and black crank set to match the brakes, black end on the outer cables. Maybe even a few black bolts on the brake pads too.