-
Could I please get a close up of that routing?
From each side if possible?
Those show the routing. Di2 cables attach to brake hoses with heatshrink, all going to and from a 3 port Junction A box on a Fourier mount.
Brommers-
Thanks @danstuff - that's the only routing I could think of.
Remove the headtube cable guides, get a 6mm Di2 grommet and run the cable through that hole then around the fork steerer and through the downtube.
The routing isn't the smoothest but you've done a great job with the heatshrink so I will use that idea to keep things tidier.
I have ordered a K-Edge junction box holder/spacer.
EDIT: My rear brake cable routing is also external. I am now remembering that I need to purchase hydro cable clamps...
-
@danstuff thanks for taking the time to share the photos.
I asked SBC to route the cables the same way and they did a great job. They said the BB area was "tight" so again, thanks for the advice to keep it 24mm Shimano.
They also used heatshrink tubing to keep the cables together.
Vince
Could I please get a close up of that routing?
From each side if possible?
It is even worst for my Lynskey Helix Pro as the rear brake hydro cable is externally routed...
Should have gone eTap (don't actually know if there are less etubes...)