Any question answered...

You are reading a single comment by @coventry_eagle and its replies. Click here to read the full conversation.

•

lf in reply to @gbj_tester

Just the sort of response I was looking for. Will drill 4mm and then take it from there. I did wonder why the remnants weren't so forthcoming with the 3mm hole drilled.

Thanks

•

coventry_eagle in reply to @lf

Spray some WD40 or GT85 before you drill and leave it overnight.

The broken bolt might just undo itself when you start drilling and pop out of the other end. Saves you from removing any remnants or re-tapping the threads

•

lf in reply to @coventry_eagle

Thanks, will do. I think the reason the bolt sheared in the first place is because the thread wasn't tapped/faced when I got the frame as new

About

@coventry_eagle started