You are reading a single comment by @PhilDAS and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
PhilDAS
Hulsroy
I don't think it requires special equipment tho.
I was going to use my Rigid tube bender and just do it to measurements from my cad drawing.
Even if done analogue with a 1:1 drawing you should be able to lay the tubes flat and check your bends.
I'll do it as a "dry run". Before welding the tube I'll put it all in the jig including internal tube. Then tack and weld the frame staying away from the entry and exit points of the stainless tube and then fix that with fillet pro once done with the TIG.