You are reading a single comment by @Jaap and its replies.
Click here to read the full conversation.
-
It's a BSA shell (33,9mm inside diameter) with a 30mm spindle, no way there is any room for a 5mm hydraulic line.
This is a picture of my PF30 shell (46mm inside diameter) where it was already difficult to run the 2,65mm di2 wires through it: https://i1.wp.com/crankzinnig.nl/wp-content/uploads/2015/02/IMG_1571.jpg
Why on earth when going custom would you route the rear hydraulic cable like this?
Wouldn't there be enough room to go fully internal under the BB (in the shell) and into the left chain stay?