-
Nah mine is still 120. The way the ends are designed might make it not too difficult a job though.
A flat dropout slotted into the ends of the stays would probably gain you like 5mm per side
-
My method improved handling imo but ment respacing the dropouts quite a bit and using size 48 shoes ment a bit of heelstrike. But I rode it like that for a good while.
https://www.flickr.com/photos/flapcrack/32117381815/in/album-72157696043572940
-
I did it the same way as @Batt- the only issue I found is that the hanger insert moves the mech about 5mm outboard so it takes some extra fiddling to index for the granny gear.
Also it's a complete pain in the arse to change a tube. Unlike Batt's I use SKS front mudguard stays for the rear guard, so they can pop out without having to undo the bolts.
-
I have a pair of those dropouts that Hulsroy made.. they’re pristine as I never used them.
Yours for postage (from dk) if you want?
You are reading a single comment by @fizzy.bleach and its replies.
Click here to read the full conversation.
M_V
🅑🅐🅣🅣
Hulsroy
Spxtz
Simba
@fizzy.bleach
Anyone ever swapped out their pomp dropouts for geared? I know you can get a little hanger to stick in... Was wondering on the best way to turn the pomp into a proper 130mm geared back end (and disc while I'm at it).
@M_V ? I know there's an old thread where @Hulsroy did it but it raised the back end about 15mm or so with some custom inserts things...