You are reading a single comment by @pdlouche and its replies.
Click here to read the full conversation.
-
Did you tap/thread the lever, or make the dowel pin locating hole or anything?
Seems on that thread it was necessary to stop it coming loose. Then again that’s what loctite’s for.
pdlouche-
No, but I did remove the lever from the body and was able to tighten up the nut good and proper. Time will tell if that’s good enough, if not it’s a five minute job to disassemble and add loctite/glue.
Plus one of my cats jumped up on my bike and caused it to topple right onto the lever, and it hasn’t budged so far.
matteroftaste
My take on the Rivendell shifters, inspired by https://singletrackworld.com/forum/topic/ghetto-shift-warning-cx-bodging-pic-heavy/with parts bin levers and suntour m90 bar shifters. Was a lot easier than anticipated, I’ll ride like this for a bit, before I decide on any improvements.