You are reading a single comment by @fizzy.bleach and its replies.
Click here to read the full conversation.
-
Oh yeah, good shout, I should do that.
@airhead, flat-pack-ability is probably a big bonus tbh as I'd like to market the design if it's a success, I'll go that route. I've only got access to a 2-axis CNC so will have to do the 'endgrain' holes by hand, but will create a jig to make that faster and more accurate.
Polygon
@fizzy.bleach
Assuming the "shelf" above the cupboard doors is the only weight-bearing surface, you could rout a groove into the back panel if you were concerned.
All options mentioned above are good. I guess it comes down to whether you value speed, simplicity of construction, cost or strength.