[SOLVED] New Rotor crank stuck in Bottom Bracket

You are reading a single comment by @Howard and its replies. Click here to read the full conversation.

•

spinnnout

Canyon confirmed the Rotor Aldhu24 for BB86 was the one - what came out and this are both 24mm axles.

I'm going to try and take off the PM and try and tap the axle out from the other side.

•

Howard in reply to @spinnnout

Any reason why completing the installation would be a bad idea? Could just grease up the spindle and tap it all the way through.

•

spinnnout in reply to @Howard

Not sure if the bottom bracket needs pressing but suspect continuing will push the middle bit back into place.

The p2m is off so may give that a go.

About

Avatar for Howard @Howard started