I am a frame builder AMA

You are reading a single comment by @M_V and its replies. Click here to read the full conversation.

•

PhilDAS

Seat tubes with 27.4 ID are gonna fit a 27.2 post after brazing right?

All the 28.6mm seat tubes I'm seeing have a 0.6mm wall thickness

•

M_V in reply to @PhilDAS

I asked about this on that facebook framebuilders group and someone replied saying that 27.4 id seat tube was for 27.2 od seat post.

Doesn't seem to make sense but there you go!

I'm using the same 27.4 id Zona tube you used on my next frame.

•

HelicopterHelicopter in reply to @M_V

You need .1 of clearance for the seat post to actually slide in, otherwise it’d be a press fit

About

Avatar for M_V @M_V started