Any question answered...

You are reading a single comment by @freezing77 and its replies. Click here to read the full conversation.

•

PhilDAS

Has anyone used a stamp set for stamping letters in brass?
I looked at sets on Amazon but reviews are really mixed. Looking for advice

•

freezing77 in reply to @PhilDAS

For what purpose, flat material? Machine engraving gives the most legible. Power hand engravers sort of OK.
Is the material solid, if so stamping will give a legible result.
Perhaps acid etching is a feasible alternative.
http://www.doitproperly.co.uk/how-to-etch-brass-or-copper/

•

PhilDAS in reply to @freezing77

Solid (relatively) or plate, it will be flat. A bit rough/handmade is fine, good in fact. I've just seen reviews on some stamps that say it isn't legible at all.
Its for a super quick added touch, not important enough to go through the effort of engraving or acid etching I don't think

About

Avatar for freezing77 @freezing77 started