You are reading a single comment by @hugo7 and its replies.
Click here to read the full conversation.
-
@PhilDAS and @JurekB - cheers.
I had wondered if I needed to order some helicoils at the same time.
@mdcc_tester - you might have a bright idea on this one....
I have a thread I'd like to clean/chase an M8 hole but there is an object (an exhaust) in the way so I can only get less than a 1/4 turn on it.
Is there a safe way to extend the chasing bit(?) by 10cm?
It's a 4 sided jobby:
Thanks.
hugo7
gbj_tester
As everybody else says, you're probably not going to beat PlusGas. What they're not telling you is that even that probably won't work for a stainless screw that has got well stuck in an aluminium housing, in the sense that the housing will be wrecked by the time you get the screw out regardless of which method you use.