-
Aside from the tips that have already been mentioned it's not an easy thing to do. It's just the more experience you have the less likely you are to end up with a streaky mess. As withered preacher mentioned you should be applying thin coats with cloths. I like mutton cloth for this job. Any brush application will be more likely to overload the surface in some areas, there are foam brushes which some people like.
You are not applying much at all but slowly darkening the wood in as even a manner as possible. Make sure you don't go over your work once it's started to dry until it's fully dry that way you should be able to take an entire coat off if it goes tits up by using a wet cloth (before it's dried). Don't let it dry if you think it looks streaky. Normally it drys very quickly. If you are watering the dye down to make it easier to work with it will take longer to dry and it needs to be very well mixed. I found wetting the surface made it worse, that might just be my technique though.
It's then equally difficult to know when you should apply the varnish especially if you don't have any test areas as it will change the depth of colour.
Sometimes you tend to judge the results too critically as well. I'm sure there are a lot of not so even professional jobs if you shine a very bright light on them. Just bear in mind it's a craft, you can't always avoid the human element with a hand polish, sometimes it still ends happily :)
Airhead-
with a hand polish, sometimes it still ends happily :)
A life lesson to us all... :)
-
That's great advice, thanks!
One thing though, the stuff I'm using dries waterproof, so if I try putting a second coat on, it just beads up and I have to wipe it off entirely.
Should I be using separate stain and varnish?
Bernhard
cyclotron3k
Speaking of staining wood; This week I've been staining some old wooden outdoor furniture using some water-based acrylic stuff.
I'm putting a lot of effort into getting a nice even coat, but once it's fully dried I'm finding that my application has been far from consistent. And then it's too late to do anything about it because it's water-repelling, and extra coats just bead up.
Any tips or tricks? Or is this just a case of getting more experience?
The tin of stain suggests wiping down the wood with slightly soapy water, which I haven't been doing. Would slightly damp wood help with consistency?