You are reading a single comment by @Dammit and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Dammit
We’re dry assembling crank/crank carrier/engine cases and fitting a couple of pistons, then bolting a head on with two vales (inlet/exhaust) and the cam fitted to see if we need to machine more material from the valve reliefs. Moment of truth this- is there enough material on the piston crown to allow pockets deep enough for our larger valves and higher lift?