Any question answered...

You are reading a single comment by @Howard and its replies. Click here to read the full conversation.

•

onyerbike

Interesting...I am wondering if it's possible to bodge it into my Bb30a frame. The frame in question is a dead CAAD12 that I want to reuse as a permanent turbo setup with these cranks.

You can't just re-space one side to even it up?

•

Howard in reply to @onyerbike

It looks like the PF30 variant which houses bb30 bearings in cups. I’m not sure but I think the c12 takes bearings pressed directly in to the frame. So this will not fit, the OD is too big.

•

onyerbike in reply to @Howard

Yep you are right. I am still going to give the original press-in BB30 bearings and the cranksets to my LBS and see if they can bodge. It's for turbo only at the moment.
•

onyerbike in reply to @Howard

So one can with normal BB30 bearings, although there's a bit of play with additional spacing. Good enough for a turbo setup.

About

Avatar for Howard @Howard started