-
None of the pics show a cable or battery location but that looks great.
Could you snap a set up pic?
SomethingOrOther-
Here it is. There's not much to see as I covered everything with tape.
There are two terminals. I remember that it didn't come with wire so I just cut up an old USB extension lead, leaving the plug on to go into a battery pack, and put the wires into the right terminals. I had to check with B+M which was right but they said that if I put them in the wrong ones it just wouldn't work rather than blow up.
I think I soldered them in - I did it two years ago for IndyPac so that's why I'm a little hazy.
It's quite a strange light in that it is open at the bottom. I think it would die if you put it directly over a wheel so that it had water directed into it, and that was why I put loads of tape over it - as well as to keep the wires stable so my amateur soldering didn't come unstuck.
I used it on indypac, then took it off, and only put it back on last week.The battery is in my top tube bag.
I'll tape the wire and tidy up a bit before I finalise the setup. The pump might come off and go somewhere else for TCR making things a bit tidier as well. I might even clean the bike!
frank9755
I use one of these as my main light:
https://www.bumm.de/en/products/e-bike-beleuchtung/parent/331/produkt/331asdc.html?
It's the e-bike version. Just re-fitted it last week.
I run it off either a 4AA battery pack or a power bank. It lasts for about a week on 4 AAs and I can turn it on/off without stopping.