Any question answered...

You are reading a single comment by @aka and its replies. Click here to read the full conversation.

•

Howard in reply to @aka

Is it a bad idea to "shim" it with epoxy?

It's probably a bad idea if you don't know what you are doing! A repair specialist will know how to do an adequate repair.

•

aka in reply to @Howard

As I said,not a repair,just need to add some material to make the wheel sit straigth,a beer can shim works but it's not permanent and a hassle to fit

•

PhilDAS in reply to @aka

washer
/ˈwɒʃə/
noun
A small flat metal, rubber, or plastic ring fixed between two joining surfaces or between a nut and a bolt to spread the pressure or act as a spacer or seal.
•

Howard in reply to @aka

So a bodge then?

If the epoxy failed, what's the worst that can happen?

About

Avatar for aka @aka started