You are reading a single comment by @Netakure and its replies.
Click here to read the full conversation.
-
I'm a steel fabricator. Cheapest way would be getting a sheet metal offcut, mark shape and holes, do holes, chop T shape with a grinder, clamp in a vice and hammer bends.
I'm unemployed now, but anyone with minimal knowledge would be able to do this. Or you can 3d print or machine it, whatever is more convenient/cheap
Netakure-
Many thanks for advice on this. But to get the already-delayed grybrid on the (wet) road ASAP, I have bought SKS rubber-band-attached mudguards.
However when time permits I hope to get a better solution in place and sell them.
I've also realised there is a dedicated mudguard thread which I should read. Cheers for now.
chez_jay
Many thanks for pic. Yes I see that I need the bends as my mounting holes are in different orientation.
I have literally no idea how one would go about getting this done though. I am sure I could do a scaled and measured drawing in e.g. Illustrator but what kind of place would do it?