You are reading a single comment by @HarmanMogul and its replies.
Click here to read the full conversation.
HarmanMogul-
For the screwdrivers, just a piece of scrap plywood with slots cut in that match the outer diameter of the tool in question. I did it that way rather than holes as I wanted to be able to pull them out rather them lift them up and potentially clashing with something else on the wall.
The chisel holders are crap, just some small squares that stick out screwed into a back piece, the chisels just sit over the squares. It's rubbish though, a bit of wind and the chisels will lean over. Will probably do that again when I can be bothered.
Hovis
Been wanting to do this for months but after seeing @Soul 's lovely garage setup, I decided to actually get around to doing it
So satisfying. I know there are far more advanced ways of doing this, but I elected for a an offcut of 18mm plywood and carefully positioned screws. Still need to get my planes and files up there, but it's mostly there. Will do another one on the other side of the garage for my more destruction type tools later