Very tiny clearance between crank spider and chainstay.

You are reading a single comment by @steelest and its replies. Click here to read the full conversation.

•

steelest

@HousecatHST on my v1 mash work, the chainring was hitting on the chainstay as well with the omnium, ended up going square taper myself. What crankset did you use?

•

Scrabble in reply to @steelest

You keep asking about crankset, but any crankset that uses a square taper BB can be made to work, as square taper BBs have different axle widths.

You could swap your sugino 75 DDs for normal 75s that run a square taper, then make sure the BB you buy is wide enough.

EDIT - Seen your response. You can use any width BB. Thats why everyone is recommending them :/
•

HousecatHST in reply to @steelest

I ended with some campag record pista, the clearance is still tight, but never had any problems.